Table of Contents
Advertisement
CLI Commands
set
set (router-lan) stp port cost
Use the set (router-lan) stp port cost command to configure Spanning Tree path cost
value for this bridge port.
Syntax:
Example:
{rt_lanr-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
slot
port
"profile-name"
{port-cost-value}
The value can range from 1 to 65535, higher values represent slower data paths. For a 100
Mb LAN a value of 19 is recommended. For a 10 Mb LAN a value of 100 is recommended.
set (router-lan) stp port priority
Use the set (router-lan) stp port priority command to configure Spanning Tree priority
value for this bridge port.
Syntax:
Example:
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
slot
port
"profile-name" The profile name for the Router interface. Name must be enclosed in
{port-priority-value}
Spanning Tree port priority for this bridge port. Range from 0 to 255, with a default of 128.
5-164
set {rtr_lan-addr} stp port cost {port-cost-value}
set 3:1 stp port cost 100
Sets the Spanning Tree port cost value at 100, on the Router in slot 3.
Slot number (1-6) that contains the Router card.
Port number of the Router is 1.
The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
set {rtr_lan-addr} port priority
{port-priority-value}
set 3:1 stp port priority 128
The example will set the STP port priority to 128, on the Router in slot 3.
The slot number (1-6) that contains the Router card.
Port number of the Router is 1.
quotes, with a maximum length of 11 characters.
Compact T1 - Release 6.1
Advertisement
Table of Contents
