Table of Contents
Advertisement
CLI Commands
set
set (router-lan) phy
Use the set (router-lan) phy command to specify the ethernet PHY (physical specifications)
speed and mode.
NOTE:
negotiation. Connecting ethernet devices with incompatible setting can
lead to severe network performance degradation, increased collisions, late
collisions, CRC errors, and undetected data corruption.
Syntax:
Example:
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
slot
port
"profile-name"
{setting}
auto
full10
full100
half10
half100
5-160
It is highly recommended that this setting be left at auto-
set {rtr_lan-addr} phy {setting}
set 3:1 phy full100
The example will force the Ethernet PHY to 100 MHz full-duplex on the Router
in slot 3.
The slot number (1-6) that contains the Router card.
Port number of the Router is 1.
The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
Auto-negotiate (highly recommended).
10 MHz full-duplex.
100 MHz full-duplex.
10 MHz half-duplex.
100 MHz half-duplex.
Compact T1 - Release 6.1
Advertisement
Table of Contents
