set (router-lan) rip
Use the set (router-lan) rip commands to specify RIP for the specified LAN interface.
set (router-lan) rip ip
Use the set (router-lan) rip ip command to specify the IP RIP for the specified LAN
interface.
Syntax:
Example:
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
slot
port
"profile-name"
{both|neither|recv|send}
both
neither
recv
send
Compact T1 - Release 6.1
set {rtr_lan-addr} rip ip {both|neither|recv|send}
set 2:1 rip ip send
The example will set RIP on the local LAN interface on slot 2 to send.
The slot number (1-6) that contains the Router card.
Port number of the Router is 1.
The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
Enable IP RIP (or IPX RIP and SAP) in both directions.
Shut IP RIP (or IPX RIP and SAP) off completely.
Enable IP RIP (or IPX RIP and SAP) in the receive direction only.
Enable IP RIP (or IPX RIP and SAP) in the send direction.
CLI Commands
set
5-161