CLI Commands
set
set (router) voip jitterbuffer
Use the set (router) voip jitterbuffer command to specify dynamic delay adjustment to
minimize delay through the jitter buffer, or maintain a static average delay through the jitter
buffer.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{dynamic|static}
dynamic
static
set (router) voip osi
Use the set (router) voip osi command to adjust the time of the Open Switch Interval (OSI)
signal.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG router card.
{milliseconds}
Range is from 500 to 2500 ms, default is 900 ms.
5-146
set {cmg_card-addr} voip jitterbuffer
{dynamic|static}
set 3 voip jitterbuffer static
The example will specify no dynamic delay adjustment for the jitter buffer, for
the CMG card in slot 3.
Perform dynamic delay adjustment to minimize delay
Maintain a static average delay, equal to two times the packet time
(Default)
set {cmg_card-addr} voip osi {milliseconds}
set 3 voip osi 1000
The example will set the OSI to 1 second, on the CMG card in slot 3.
Compact T1 - Release 6.1