Table of Contents
Advertisement
set ethernet ip address
Use the set ethernet ip address command to set the Ethernet address for the Compact T1.
Syntax:
Example:
{ip-addr}
Set the IP address for the Compact T1, using the form xxx.xxx.xxx.xxx, where xxx is a
number from 0 to 255.
[mask]
Set the subnet mask, using the form xxx.xxx.xxx.xxx, where xxx is a number from 0 to 255.
This is an optional setting.
set (fxo)
Use the set (fxo) command to setup one/all of the voice channels of an FXO card. The command
specifies the list of voice channels within that card, and the setting to apply.
Syntax:
Example:
{fxo-addr}
List of voice channels to apply setting to, in the form {slot:port}.
slot
port
{setting}
rxgain
signal
txgain
Compact T1 - Release 6.1
set ethernet ip address {ip-addr} [mask]
set ethernet ip address 172.26.100.25 255.255.255.0
Sets the Adit IP address to 172.26.100.25, and a subnet mask of 255.255.255.0.
set {fxo-addr} {setting}
set 2:1 signal ls
Set the FXO on slot 2, port 1 to signaling type loop start.
Slot number 1 - 6, location of the FXO card
Port number or range
The receive level range is -9 to +7 (db). Available values are -9, -7, -6, -5,
-4, -3, -2, 0, 2, 3, 4, 5, 6, and 7
Set the DS0 signaling type
dpt
Set the DS0 to Dial Pulse Terminate
gs
Set the DS0 to Ground Start signaling
ls
Set the DS0 to Loop Start signaling
lscpd
Set the DS0 to Loop Start Calling Party Disconnect
The transmit level range is -9 to +7 (db). Available values are -9, -7, -6,
-5, -4, -3, -2, 0, 2, 3, 4, 5, 6, and 7
CLI Commands
set
5-79
Advertisement
Table of Contents
