Set (Bri) - Black Box Compact T1 MT850A User Manual

set (bri)

Use the set (bri) command to setup the ISDN BRI card.
Syntax:
Example:
{bri-addr}
The {slot:port} address of the BRI card you want to apply the changes to.
slot
port
{setting}
crv
Set the Call Reference Value, when the BRI is set to 4:1 mode (lt4to1tdm). The CRV
value is between 1-768.
down
Take the ISDN line Out-of-Service.
threshold
Set the defect thresholds for ISDN lines to one of the following:
day
hour
value
up
Put the ISDN line In-Service.
Compact T1 - Release 6.1
set {bri-addr} {day|hour} {es|ses} {value}
set 3:4 threshold day ses 30
To set the daily threshold to 30 Severely Errored Seconds on port 4 of a BRI card
in slot 3.
A for the controller card, or 1 - 6 for service cards.
Port number or range.
Set the thresholds for the daily intervals.
es Set the threshold for Errored Seconds (ES)
ses Set the threshold for Severely Errored Seconds (SES)
Set the thresholds for hourly intervals.
es Same as above
ses Same as above
range is 1 - 65535 seconds.
CLI Commands
set
5-71