Table of Contents
Advertisement
CLI Commands
set
set (ds1)
Use the set (ds1) command to set up DS1 interfaces. The command specifies a range of
interfaces and the setting to apply.
Syntax:
Example:
{ds1-addr}
DS1 address in the form {slot:port}.
slot
port
{setting}
down
up
bpviolation
equipment
fdl
5-76
set {ds1-addr} {setting}
set a:1 framing esf
To set DS1 1 (port 1) on the controller (slot A) to use ESF framing.
A for the controller card, or 1-6 for service cards.
Port number range or all.
Set the DS1 as Out-of-Service
Set the DS1 as In-Service. Enables alarm reporting (and LED) for the
port specified
Set the bipolar violation alarm threshold. Command only functional
when in TR-08 mode
none
tenneg4
tenneg5
tenneg6
Set equipment loopback on the DS1
Note: this feature is only available through Quad T1 cards. It is not
available on the controllers.
loopdown
loopup
Set the Facilities Data Link (FDL) capabilities
none
alm13
alm16
t1403
Remove bipolar violation alarm
Set bipolar violation alarm threshold to .0001
Set bipolar violation alarm threshold to .00001
Set bipolar violation alarm threshold to .000001
Disable equipment loopback on the DS1
Enable equipment loopback on the DS1
Disable FDL output messages
Enable TR-08 alarm 13 FDL messages
Enable TR-08 alarm 16 FDL messages
Enable T1.403 FDL performance messages
Compact T1 - Release 6.1
Advertisement
Table of Contents
