Table of Contents
Advertisement
T1 Controller Card
Configuration
Configuration
Options on the Controller card are set by the DIP switches or the Command Line
Interface (CLI).
NOTE:
CLI Commands
The following commands are used to configure the Controller card. For detailed
information on these commands, see Chapter 5, CLI Commands.
l
connect
Creates two-way connections between channels
l
disconnect
Removes a connection created by the connect command
l
set clock
Sets the primary and secondary transmit clock
l
set date
Sets the date for the system
l
set (ds1)
Sets up the DS1 interfaces (up, down, bpviolation, fdl, framing, id string,
lbo, line loopup, linecode, loopdetect, payload, threshold)
l
set ipds0
Sets up the DS0 management channel (assign, disable, down, IP address, up)
l
show (ds1)
Displays current settings for DS1 (circuit ID, up, down, framing, line
coding, clock source, line build out, loop code detection, loop back, fdl type)
l
show ipds0
Displays the settings for the DS0 management channel
l
status (ds1)
Displays the status of the DS1 (receive, transmit, loopback)
l
status ipds0
Display the status of the DS0 management channel
6-8
The default IP address for the Controller is 10.0.0.10.
Compact T1 - Release 6.1
Advertisement
Table of Contents
