Table of Contents
Advertisement
CLI Commands
set
set (router) voip sdpaddress
Use the set (router) voip sdpaddress command to set the address value to be used for the
origin and connection lines in the SDP.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{domainname|gatewayid|ip|ip-addr}
domainname Use the DNS domain name if DNS is enabled or DMG IP address if
gatewayid
ip
ip-addr
5-152
set {cmg_card-addr} voip sdpaddress
{gatewayid|domain-name|ip|ip-addr}
set 3 voip sdpaddress domainname
The example will configure the SDP address value to match the DNS domain
name.
DNS is disabled.
Use the MGCP gateway ID.
Use the CMG IP address.
Use this IP address, in the form xxx.xxx.xxx.xxx, where xxx is a
number from 0 - 255.
Compact T1 - Release 6.1
Advertisement
Table of Contents
