CLI Commands
set
set (router) reboot
Use the set (router) reboot command to set automatic reboot after an upload of code or
configuration file.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{code|config}
code
config
{disable|enable}
disable
enable
set (router) rip
Use the set (router) rip command to specify RIP packets to transmit and receive.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{recv|send}
recv
send
{v1|v1and2|v2}
v1
v1and2
v2
5-136
set {rtr_card-addr} reboot {code|config}
{disable|enable}
set 5 reboot both disable
Disable automatic reboot after upload for the Router in slot 5.
Automatic reboot after code upload
Automatic reboot after configuration upload
Will disable automatic reboot
Will enable the automatic reboot after upload of a file
set {rtr_card-addr} rip {recv|send} {v1|v1and2|v2}
set 3 rip recv v1
The example will configure receive RIP on the Router card in slot 3 to V1.
Set RIP receive version
Set RIP send version
Set RIP to version 1
Set RIP to version 1 and version 2
Set RIP to version 2
Compact T1 - Release 6.1