Table of Contents
Advertisement
Card Configuration
The FXS voice card can be configured, using DIP switches on the card, to support
either FXS loopstart or FXS groundstart signaling, with various transmit and receive
attenuation options.
Note that the attenuation settings configured via DIP switches apply to all eight
channels. For different attenuation options for individual channels, use the CLI.
CLI Commands
The following commands are used to configure the FXS cards. For detailed information
on these commands, see Chapter 5, CLI Commands.
l
connect
Creates two-way connections between channels
l
disconnect
Removes a connection created by the connect command
l
set (fxs5G)
To setup the voice channels parameters of a FXS 5G card (rx gain, signal, tx
gain, impedance and wink time)
l
show (fxs5G)
Displays the settings (type, signaling, rx gain, tx gain, impedance, wink
time) for the FXS 5G
l
show impedance
Displays the impedance settings for FXS 5G cards
l
status (fxs5G)
Displays the status (AB bits received, AB bits transmitted, signal, T1
activity, trunk processing) of the specified FXS (AB Bit Monitoring)
Compact T1 - Release 6.1
FXS Voice Card
Card Configuration
8-7
Advertisement
Table of Contents
