Table of Contents
Advertisement
CLI Commands
set
set (router) syslog
Use the set (router) syslog commands to configure the Router to send alarm and event
messages to a Syslog server.
set (router) syslog enable/disable
Use the set (router) syslog enable/disable command to enable and disable sending alarm
and event messages to an external SysLog server from the Router.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{disable|enable}
disable
enable
set (router) syslog facility
Use the set (router) syslog facility command to set the Syslog facility value that the Router
card will report to a syslog server in each message.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{value}
The range of valid facility values is from 0 to 23, with a default of 16 (local use 0).
5-142
set {rtr_card-addr} syslog {disable|enable}
set 3 syslog enable
The example will enable alarms and event messages to the external SysLog
server, on the Router in slot 3.
Disable SysLog protocol
Enable SysLog protocol
set {rtr_card-addr} syslog facility {value}
set 3 syslog facility 16
The example will set the Syslog facility value to 16, on the Router in slot 3.
Compact T1 - Release 6.1
Advertisement
Table of Contents
