Table of Contents
Advertisement
CLI Commands
show
show (router-wan) firewall
The show (router-wan) firewall command displays the current firewall filter settings for the
specified WAN interface.
Syntax:
Example:
SLOT 5:
WAN Firewall Settings for LosAngeles:
Service(s)
1. SMTP
2. Telnet
Last ! Any
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
show (router-wan) nat bypass
Use the show (router-wan) nat bypass command to see the current list of NAT bypass entries
for the WAN interface on the specified Router card. This command applies to the IP Router
only.
Syntax:
Example:
SLOT 2:
WAN NAT Bypass Address Settings for RemoteAdit:
{rtr_card-addr}
The slot number (1-6) that contains the IP Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
5-242
show {rtr_card-addr} {"wan-name"} firewall
show 5 "LosAngeles" firewall
LAN Device(s)
192.0.0.0/8
100.0.0.0/24
*
show {rtr_card-addr} {"wan-name"} nat bypass
show 2 "RemoteUnit" nat bypass
IP Address
156.65.0.0
201.23.16.0
Total: 2
==> 192.0.0.0/8
==> 200.0.0.0/24
<== ==> *
Netmask
255.255.255.0
255.255.255.0
WAN Device(s)
Compact T1 - Release 6.1
Lo
Log
Alm
Advertisement
Table of Contents
