Table of Contents
Advertisement
CLI Commands
set
set (router-voice) slash
Use the set (router-voice) slash command for configuring a CMG endpoint so that the implied
slash, "/", between the endpoint prefix and suffix can be suppressed. This command applies to
the CMG Router card only.
Syntax:
Example:
{cmg_voice-addr}
In the form {slot:voip:port}
slot
voip
channel Channel number for the router is 1-48, range or all
{disable|enable}
disable
enable
set (router-voice) tos
Use the set (router-voice) tos command to set the default value for the Type of Service (TOS)
byte in the IP header of outgoing VoIP packets for the specified channel(s). This value may be
overridden by the call agent on a call-by-call basis. This command applies to the CMG Router
card only.
Syntax:
Example:
{cmg_voice-addr}
In the form {slot:voip:port}
slot
voip
channel Channel number for the router is 1-48, range or all
{2-hex-digits}
Specified bits to be sent in TOS byte. The first (leftmost) 3 bits represent the "precedence"
or priority. Bit 4 (from the left) indicates optimize for delay. Bit 5 indicates optimize for
throughput. Bit 6 indicates optimize for reliability.
5-180
set {cmg_voice-addr} slash {disable|enable}
set 2:1:1:all slash disable
The example will disable use of slash between endpoint prefix and suffix.
The slot number (1-6) that contains the CMG card.
To designate VoIP 1:1 is used.
Suppress the use of a slash between the endpoint prefix and suffix.
Insert a slash between the endpoint prefix and suffix. (Default)
set {cmg_voice-addr} tos {2-hex-digits}
set 2:1:1:all
The example will set the default priority 5 (in the original classification scheme)
for VoIP packets for all voice channels of the CMG card in slot 2.
The slot number (1-6) that contains the CMG card.
To designate VoIP 1:1 is used.
tos 0xA0
Compact T1 - Release 6.1
Advertisement
Table of Contents
