Table of Contents
Advertisement
CLI Commands
set
set ipds0
Use the set ipds0 command to setup the DS0 management channel.
Note: the DS0 selected as the DS0 management channel can only reside on the Controller T1.
Syntax:
Example:
{setting}
assign
delete
down
ip address
up
[ds0-addr|ip-addr]
In the form {slot:port:channel}.
slot
port
channel
ip-addr
5-82
set ipds0 {setting} [ds0-addr|ip-addr]
set ipds0 assign a:1:24
The example sets the DS0 management channel to slot A (Controller), port 1,
channel 24.
Assign the DS0 as the IP management channel
Removes the IP over DS0 management channel (Default)
Set the DS0 management channel down (Default)
Set the DS0 management channel's IP address and optional subnet mask
Set the DS0 management channel up (enables)
A for the controller card
Port number or range.
Channel number or ranges.
Setup the DS0 management channel IP address and the optional subnet
mask, in the form of xxx.xxx.xxx.xxx, where xxx is between 0-255.
Compact T1 - Release 6.1
Advertisement
Table of Contents
