Table of Contents
Advertisement
CLI Commands
set
set (v35)
Use the set (v35) command to setup V.35 ports. The command specifies the range of channels
within that card, and the setting to apply.
Syntax:
Example:
{v35-addr}
In the form of {slot:port}.
slot
port
{setting}
Setting to apply one of the following:
clock
cts
data
equipment
line
5-202
set {v35-addr} {setting}
set 6:1 rxclk normal
To set port 1 (v.35) on slot 6 to no inversion on the receive clock
Slot number (1-6) of the Compact T1 where the V.35 card is located
Port number or range.
Set the clock source to one of the following:
source
to the internal Stratum 4E oscillator
external
to the external source
Set the Clear To Send operation mode to one of the following:
cd
follow CD
high
force CTS high
low
force CTS low
rts
follow RTS
Set the data mode to one of the following:
invert
invert the receive and transmit data
normal
do not invert receive and transmit data
Sets the V.35 port to equipment loopback, which loops the transmit V.35
signal back toward the V.35 receive (toward the T1)
loopdown
disable equipment loopback
loopup
enable equipment loopback
Sets the V.35 port to line loopback, which loops the received V.35 signal
back toward the V.35 signal toward the V.35 transmit (away from T1)
loopdown
disable line loopback
loopup
enable line loopback
Compact T1 - Release 6.1
Advertisement
Table of Contents
