Table of Contents
Advertisement
set (router) voip g729a
Use the set (router) voip g729a command to enable or disable the G.729 codec in the
CMG. This command takes effect after the card has been reset.
NOTE:
key is entered to enable this feature it will not be usable. The command, however,
will still succeed to allow for pre-configuration. For additional information on how to
purchase this feature, contact Customer Service.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{disable|enable}
disable
enable
Compact T1 - Release 6.1
The G.729 feature is protected by a software key. Until an appropriate
set {cmg_card-addr} voip g729a {disable|enable}
set 3 voip g729a enable
The example will enable G.729 on the CMG card in slot 3.
Will prevent the use of the G.729 codec.
Will allow the use of the G.729 codec. Enable is the default.
CLI Commands
set
5-145
Advertisement
Table of Contents
