Table of Contents
Advertisement
CLI Commands
set
set (router) voip
Use the set (router) voip commands to set Voice over IP (VoIP) parameters. This command
applies to the CMG Router card only.
set (router) voip default
Use the set (router) voip default command to set all VoIP options to their default values.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
set (router) voip dtmf edge
Use the set (router) voip dtmf edge command to configure the CMG to notify DTMF
digits on the leading or trailing edge. Setting this configuration item to leading edge shall
cause the CMG to act on DTMF digits, for collection or notification purposes, at the time
the key is pressed. Setting this configuration item to trailing edge shall cause the CMG to
act on DTMF digits at the time the key is released. This command takes effect immediately.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{leading|trailing}
leading
trailing
5-144
set {cmg_card-addr} voip default
set 3 voip default
The example will set the VoIP options to their default settings, on the CMG card
in slot 3.
set {cmg_card-addr} voip dtmf edge {leading|trailing}
set 3 voip dtmf edge trailing
The example will set the CMG in slot 3 to notify the call agent of digits when
the key is released.
Will cause the CMG to act on DTMF digits, for collection or notification
purposes, at the time the key is pressed.
Will cause the CMG to act on DTMF digits at the time the key is
released.
Compact T1 - Release 6.1
Advertisement
Table of Contents
