Table of Contents
Advertisement
CLI Commands
set
set (router-wan) ppp
Use the set (router) ppp command to configure the PPP (Point-to-Point Protocol) on the
specified Router card.
set (router) ppp auth ofremote user
Use the set (router) ppp auth ofremote user command to set the CHAP or PAP name by
which a remote PPP device is authenticated by this Adit.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{profilename|"protocol-name"}
profilename
"protocol-name"
5-190
set {rtr_card-addr} {"wan-name"} ppp auth ofremote
user {profilename|"protocol-name"}
set 5 "LosAngeles" ppp auth ofremote user profilename
The example will set the PPP authentication user name for the WAN interface
named "LosAngeles" tin slot 1 to equal the profile name.
Use the profile name as the CHAP or PAP user name.
The CHAP or PAP user name. A maximum of 16 characters,
enclosed in quotes.
Compact T1 - Release 6.1
Advertisement
Table of Contents
