Table of Contents
Advertisement
add (router) uploaduser
Use the add (router) uploaduser command to specify a host that is allowed to upload either
the configuration or software files to the specified Router card.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{both|code|config}
both
code
config
{all|ip-addr}
all
ip-addr
{"profile-name"}
The name of the remote WAN or LAN profile that can be used for the upload. This name
must be enclosed in quotes.
Compact T1 - Release 6.1
add {rtr_card-addr} uploaduser {both|code|config}
{all|ip-addr} {"profile-name"}
add 3 uploaduser code all "LosAngeles"
The example will allow any user to upload the code file from the Router
interface named "LosAngeles". The Router is located in slot 3.
Will allow user to upload both the code file and the configuration file
from the Router
Will allow user to upload the code file from the Router
Will allow user to upload the configuration file from the Router
Will allow upload from anywhere
The IP address to allow upload boot from. In the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255
CLI Commands
add
5-11
Advertisement
Table of Contents
