Table of Contents
Advertisement
CLI Commands
set
set (bri) autoactivate
Use the set (bri) autoactivate command to set the auto-activate option for the card. This option
can only be enabled while in 4 to 1 TDM LT Mode.
This option is used to establish the D channel when the FDL link can not be used. If Auto-
activation is enabled, all commands initiated by the Switch and normally processed over the
FDL will be ignored, commands to control Loop Back or Corrupt CRC tests will also be
ignored. The Compact T1 will not be capable of reporting to the Switch any changes in the
ISDN line status, such as Loss of Signal, on an automatically activated line. Status changes and
alarms will be available through Compact T1 CLI.
Syntax:
Example:
{bri_card-addr}
The slot number (1-6) that contains the BRI card.
{off|on}
off
on
set (bri) mode
Use the set (bri) mode command to set the mode for the ISDN BRI Service.
Syntax:
Example:
{bri_card-addr}
The slot number (1-6) that contains the BRI card.
{setting}
lt3ds0
lt4to1tdm
nt3ds0
5-72
set {bri_card-addr} autoactivate {off|on}
set 3 autoactivate on
To set the auto-activate on for the card in slot 3.
Turn off the automatic-activation feature.
Enable the automatic-activation feature.
set {bri_card-addr} mode {setting}
set 4 mode nt3ds0
To set the BRI card in slot 4 to use 3 DS0 LUNT
Set BRI card mode to 3 DS0 LULT, used primarily for a subscriber line
Set the BRI card mode to 4 to 1 TDM LULT
Set BRI card mode to 3 DS0 LUNT, used primarily for a central office
connection
Compact T1 - Release 6.1
Advertisement
Table of Contents
