Table of Contents
Advertisement
CLI Commands
set
set (fxs5G)
Use the set (fxs5G) command to setup voice channels of an FXS 5G card. The command
specifies the list of voice channels, and the setting to apply.
Syntax:
Example:
{fxs5G-addr}
Voice channels to apply setting to, in the form of {slot:port}.
slot
port
{setting}
impedance
rxgain
signal
txgain
winktime
5-80
set {fxs5G-addr} {setting}
set 3:1-8 impedance 19
Sets the impedance of the FXS 5G card, in slot 3, to 900 ohms +2.16 F
( -Law), see show impedance for the listing of index numbers.
Slot number 1 - 6, location of the FXS 5G card
Port number or range
Sets the line impedance (see the following chart). Default for the FXS
5G is index 19 (900 ohms +2.16 F -Law)
See show impedance command.
The Receive direction is Network to Analog, with a range of -12 to +6
(dB). Available in .25 dB increments.Default setting is -6
Set the DS0 signaling type
gs
Set to Ground Start signaling
gsrb
Set to Ground Start signaling with reverse battery
gsw
Set to Ground Start Wink signaling
gswrb
Set to Ground Start Wink signaling with reverse battery
ls
Set to Loop Start signaling
lsrb
Set to Loop Start signaling with reverse battery
The Transmit direction is Analog to Network, with a range of -12 to +6
(dB). Available in .25 dB increments. Default setting is -3
Set the wink time from 105 ms to 300 ms in 3 ms increments. Enter
value or type "Default" (135 ms). Setting the wink time for any channel
sets it for all channels on this card.
Compact T1 - Release 6.1
Advertisement
Table of Contents
