set id
Use the set id command to the unit ID.
Syntax:
Example:
{"id-name"}
The name must be unique with a maximum of 20 characters. Name must be enclosed in
quotes.
set ip gateway
Use the set ip gateway command to set the IP gateway address (also known as the default route)
for the Compact T1. The command specifies the numeric Internet Protocol (IP) address. The
new gateway address will not take effect until Controller is reset (reset command).
Syntax:
Example:
{ip-addr}
Set the IP gateway address for the Compact T1, using the form xxx.xxx.xxx.xxx, where xxx
is a number from 0 to 255.
Compact T1 - Release 6.1
set id {"id-name"}
set id "ADIT600"
ADIT600>
set ip gateway {ip-addr}
set ip gateway 192.168.100.1
CLI Commands
set
5-81