Table of Contents
Advertisement
CLI Commands
set
set (ocudp) baud
Use the set (ocudp) baud command to configure the Baud Rate for OCU-DP ports.
Syntax:
Example:
{ocudp-addr}
The {slot:port} address of the OCU-DP card you want to apply the changes to.
slot
port
{rate}
2400
4800
9600
19200
38400
56000*
64000
5-86
set {ocudp-addr} baud {rate}[sw56|sw56cp]
set 3:2 baud 2400
Set the baud rate on port 2 to 2400, on the OCU-DP card in slot 3
Slot number (1-6) where the OCU-DP is located
Port number or range.
Set OCU-DP baud rate to 2400
Set OCU-DP baud rate to 4800
Set OCU-DP baud rate to 9600
Set OCU-DP baud rate to 19200
Set OCU-DP baud rate to 38400
Set OCU-DP baud rate to 56000 (Default)
sw56
Set to switched 56 service
sw56cp
Set to switched 56 service with call progress capability. Sends
special call progress CMI codes to DSU.
Set OCU-DP baud rate to 64000
Compact T1 - Release 6.1
Advertisement
Table of Contents
