Table of Contents
Advertisement
set (ds0)
Use the set (ds0) command to setup one or all DS0s in a DS1. The command specifies DS0 or
range of DS0s, and the setting to apply.
Syntax:
Example:
Example:
{ds0-addr}
List of DS0 channels to apply setting to, in the form {slot:port:channel}.
slot
port
channel
{setting}
signal
type
Compact T1 - Release 6.1
set {ds0-addr} {setting}
set 3:1:1-4 type voice
To set the traffic type to voice on channels 1 - 4 on port 1 of slot 3.
set a:1:1-4 signal emi
To set the signal type to E&M immediate start for channels 1 - 4 on port 1 of slot
A.
A for the controller card, or 1 - 6 for service cards.
Port number or range.
Channel number or range.
emdw
E&M delayed wink start. Used for ANI/DNS
emi
E&M immediate start with ringback
emicpd
E&M immediate start with calling party disconnect with ringback
emw
E&M wink start
gs
Ground start signaling
ls
Loop start signaling
plar
D4 PLAR (Private Line Automatic Ringdown) signaling.
data
Set the DS0 up to carry data (clear channel)
voice
Set the DS0 up to carry voice traffic (robbed-bit signaling)
CLI Commands
(used for D3 PLAR and DPT)
set
5-75
Advertisement
Table of Contents
