Table of Contents
Advertisement
CLI Commands
set
set (router-wan) nat enable/disable
Use the set (router-wan) nat command to enable and disable Network Address Translation
(NAT) on a specified WAN interface.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{disable|enable}
disable
enable
set (router-wan) nat ports
Use the set (router-wan) nat ports command to configure Network Address Translation
(NAT) to dynamically map ports or preserve them. This field should only be set to
"preserved" if an application that you are using requires a specific port number.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{dynamic|preserved}
dynamic
preserved
5-188
set {rtr_card-addr} {"wan-name"} nat {disable|enable}
set 1 "LosAngeles" nat enable
The example will set the WAN interface named "LosAngeles" on the Router in
slot 1 to enable NAT mapping.
Disable NAT mapping.
Enable NAT mapping.
set {rtr_card-addr} {"wan-name"} nat ports
{dynamic|preserved}
set 1 "LosAngeles" nat ports dynamic
The example will set the WAN interface named "LosAngeles" on the Router in
slot 1 to enable dynamic NAT port mapping.
Set NAT port mapping to be dynamic.
Preserve original port.
Compact T1 - Release 6.1
Advertisement
Table of Contents
