Table of Contents
Advertisement
show (ocudp)
Use the show (ocudp) to display baud, loopdetect, error correction, switched and enhanced
switched service and secondary channel provisioning.
Syntax:
Example:
SLOT 2:
Settings for OCUDP Port 1:
{ocudp-addr}
The {slot:port} address of the OCU-DP card to display.
slot
port
show radius
The show radius command displays the RADIUS configuration settings for the Controller.
Syntax:
Example:
RADIUS Configuration Parameters:
Authentication: enabled for
NAS Identifier:
Retry count:
Timeout (sec):
Server(1) :
Server(2) :
Server(3) :
Compact T1 - Release 6.1
show {ocudp-addr}
show 2:1
Up/Down:
Baudrate:
Loopdetect Types Enabled:
Error Correction:
Secondary Channel:
Slot number (1-6) of the chassis where the OCU-DP is located. If no port
is specified, all ports will be displayed.
Port number or range.
show radius
show radius
Slot 4
Slot 5
3
3
UNUSED
UNUSED
UNUSED
UP
56000
CSU Non-Latching
DSU Non-Latching
OCU Non-Latching
DISABLE
DISABLE
CLI Commands
show
5-217
Advertisement
Table of Contents
