Add (Router) Snmp Community - Black Box Compact T1 MT850A User Manual

CLI Commands
add

add (router) snmp community

Use the add (router) snmp community command to add a SNMP community to an interface
on the specified Router card.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{both|read|write}
both
read
write
{"community-name"}
Name of the community to add with a maximum length of 10 characters. Must be enclosed
in quotes.
{ip-addr}
The IP address of the host that can access the SNMP agent via this community, in the form
of xxx.xxx.xxx.xxx, where xxx is between 0-255. The address "0.0.0.0" allows any host.
5-8
add {rtr_card-addr} snmp community {both|read|write}
{"community-name"} {ip-addr}
add 2 snmp community both "commune" 192.168.100.245
The example will allow the host 192.168.100.245 read/write access to the
Router card SNMP agent using the community name "commune". The Router is
located in slot 2.
Will set the community to be read/write
Will set the community to be read-only
Will set the community to be write-only
Compact T1 - Release 6.1