Table of Contents
Advertisement
Router (IP) Card
Card Configuration
l
set (router-lan) filter forward
Set the forwarding mode for Layer 2 filters added to the specified LAN
interface.
l
set (router-lan) framing
Set which ethernet frame types are supported on the Router LAN interface.
l
set (router-lan) gateway
Specify a default IP gateway for the specified LAN interface.
l
set (router-lan) ip address
Specify an IP address for the specified LAN interface.
l
set (router-lan) ipx network
Specify an IPX network numbers for the four IPX LAN frame types.
l
set (router-lan) phy
Specify the ethernet PHY (physical specifications) speed and mode.
l
set (router-lan) rip
Set the IP RIP for the LAN interface.
l
set (router-lan) stp
Setup the Spanning Tree Protocol on this interface.
l
set (router-lan) up/down
Set the LAN interface up or down.
l
set (router-trunk) encapsulation
Specify the encapsulation to use on the Router interface.
l
set (router-trunk) multilink group
Specify that a trunk is part of a multilink PPP group
l
set (router-trunk) up/down
Set the Router trunk up or down.
l
set (router-wan) dlci
Configure the DLCI for a specified WAN interface that will be using a frame
relay encapsulated trunk.
l
set (router-wan) gre
Configure the GRE tunneling for a specified WAN interface.
l
set (router-wan) ip
Set the IP traffic handling on the WAN interface.
13-12
Compact T1 - Release 6.1
Advertisement
Table of Contents
