Table of Contents
Advertisement
l
set (router) stp
Configure the Spanning Tree Protocol on the router
l
set (router) syslog
Configure the Router to send alarm and event messages to a Syslog server
l
set (router) voip
Set the Voice Over IP (VoIP) parameters
l
set (router-lan) collision
Configure collision alarms
l
set (router-lan) filter forward
Specify the forwarding mode for Layer 2 filters on the LAN interface
l
set (router-lan) framing
Specify which ethernet frame types are supported on the LAN interface
l
set (router-lan) gateway
Specify a default IP gateway for the specified LAN interface
l
set (router-lan) ip address
Specify an IP address for the specified LAN interface
l
set (router-lan) ipx network
Specify an IPX network numbers for the four IPS LAN frame types
l
set (router-lan) phy
Specify the ethernet PHY (physical specifications) speed and mode.
l
set (router-lan) rip
Specify IP RIP for the LAN interface
l
set (router-lan) stp
Configure the Spanning Tree Protocol on the LAN interface
l
set (router-lan) up/down
Set the LAN interface up or down.
l
set (router-trunk) encapsulation
Specify the encapsulation to use on the Router interface
l
set (router-trunk) multilink group
Specify that a trunk is part of a multilink PPP group
l
set (router-trunk) up/down
Set the Router trunk up or down
Compact T1 - Release 6.1
Router (CMG) Card
Card Configuration
14-13
Advertisement
Table of Contents
