Table of Contents
Advertisement
CLI Commands
set
set (router-lan) collision threshold
Use the set (router-lan) collision threshold command to specify the thresholds used to
determine excessive collision alarm state.
Syntax:
Example:
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
slot
port
"profile-name"
{high|low}
high
low
{count}
The number of collisions in the collision interval time period. Range is 0 - 65536.
5-154
set {rtr_lan-addr} collision threshold {high|low}
{count}
set 3 "Adit50" collision threshold high 500
The example will set the high alarm threshold to 500, for the local LAN interface
on slot 3.
Slot number (1-6) that contains the Router card.
Port number of the Router is 1.
The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
The number of collisions in the collision interval time period above
which an excess collision alarm is raised.
The number of collisions in the collision interval time period below
which a standing excess collision alarm is cleared.
Compact T1 - Release 6.1
Advertisement
Table of Contents
