Set (Router) Enhanced Security; Set (Router) Hookflash - Black Box Compact T1 MT850A User Manual

set (router) enhanced security

Use the set (router) enhanced security command to enable or disable enhanced login security
on the Router. When enabled the user will not receive any login prompt or other output until the
security password is typed. The security password is set via the set (router) password command.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{disable|enable}
disable
enable

set (router) hookflash

Use the set (router) hookflash command to specify the flash maximum time in milliseconds.
This is the time beyond which a disconnect, rather than a hookflash event, is declared. Flash
event processing may be turned off by setting this parameter to zero. This command applies to
the CMG Router card only.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{milliseconds}
Maximum flash length, between 500 and 1500 milliseconds, or 0. Default is 1500
milliseconds.
Compact T1 - Release 6.1
set {rtr_card-addr} enhanced security
{disable|enable}
set 5 enhanced security enable
The example will enable the enhanced security on the Router card in slot 5.
Note: A set 5 password security "password" command must be completed
before the enhanced security can be enabled.
See, set (router) password on page 5-129
Disable enhanced login security
Enable enhanced login security
set {cmg_card-addr} hookflash {milliseconds}
set 5 hookflash 500
The example will set the hookflash to 500 milliseconds (half a second) on the
CMG card in slot 5.
CLI Commands
set
5-103