Table of Contents
Advertisement
set (router) mgcp algorithmname
The set (router) mgcp algorithmname is an interoperability command to configure non-
default MGCP designations for voice coding algorithms supported by the CMG. MGCP
algorithm names are used in the "a:" attribute in the Local Connection Options (L:)
parameter line of a CRCX or MDCX command. The CMG will ignore the case of
characters in algorithm names received in MGCP commands from a call agent. Default
algorithm names are taken or derived from standard encoding names registered at IANA,
as specified at www.iana.org, the RTP section. This command takes effect immediately and
applies to the CMG Router card only.
The default MGCP algorithm names are given in column 2 below.
Algorithm
g711 mu-law
g711 A-law
g729A
g726-16 kb/s
g726-24 kb/s
g726-32 kb/s
g726-40 kb/s
NOTE:
key is entered to enable this feature it will not be usable. The command, however,
will still succeed to allow for pre-configuration. For additional information on how to
purchase this feature, contact Customer Service.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{setting}
Enter one of the following: g711mu, g711a, g726_16, g726_24, g726_32, g726_40, g729a.
{"algorithm-name"}
The MGCP algorithm name for the CMG card. This name must be enclosed in quotes, with
a maximum of 16 characters.
Compact T1 - Release 6.1
CMG Algorithm ID
g711mu
g711a
g729a
g726_16
g726_24
g726_32
g726_40
The G.729 feature is protected by a software key. Until an appropriate
set {cmg_card-addr} mgcp algorithmname {setting}
{"algorithm-name"}
set 1 mgcp algorithmname g711mu "Gxxx"
The example will set the mgcp algorithm coding to G.711 for mu-law and name
it "Gxxx", for the CMG card in slot 1.
CLI Commands
MGCP Algorithm Name
PCMU
PCMA
G729A
g726-16
g726-24
g726-32
g726-40
set
5-109
Advertisement
Table of Contents
