System Backup Disable - Efficient Networks Router family Command Line Interface Manual

Chapter 4: System Commands
The following command clears all addresses from the list.
-> system backup delete
Response
Command prompt.

system backup disable

Disables the Dial Backup option in the router.
NOTE:
Because Dial Backup uses the console port, you cannot access the command line via
the console port while Dial Backup is enabled. You must use the Web GUI interface or
a Telnet session to disable Dial Backup.
NOTE:
If you do not use the
temporarily disabled and it is re-enabled at the next reboot. Temporarily disabling Dial
Backup stops Dial Backup, but it does not change the use of the console port. To
disable Dial Backup across reboots, see
page 6-15
To re-enable the Dial Backup option, use the
more information about Dial Backup, refer to
Technical Reference Guide.
Mgmt Class
Network (R/W)
Input Format
system backup disable
Parameters
None
Response
Command prompt.
Page 4-20
save command to save this change, Dial Backup is only
of the Technical Reference Guide.
Efficient Networks
all all
"Disabling and Re-Enabling Dial Backup" on
system backup enable
"Dial Backup" on page 6-7
®
Router family
Command Line Interface Guide
command. For
of the
Efficient Networks
®