Stateful Firewall Commands - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

STATEFUL FIREWALL COMMANDS

CHAPTER 18
This section contains command descriptions for the key-enabled Stateful Firewall
feature. For an overview of firewalls and more detailed information on Stateful
Firewall, see
see eth ip
The firewall commands found in this section include:
Command
firewall ?
firewall allow
firewall clearcounter
firewall clearcounter all
firewall delete
firewall delete all
firewall deny
firewall list
firewall modify
firewall set
firewall setdroppkt-
threshold
®
Efficient Networks
"Stateful Firewall" on page 4-34.
firewall, in Chapter 5, Ethernet Interface
Table 18-1: Firewall Command Listing
Lists the supported stateful firewall keywords.
Creates a firewall rule for inclusion in the allow
rules list.
Clears the counter for a specified rule.
Clears counters for all stateful firewall rules.
Deletes a single firewall rule or range of firewall
rules based on firewall rule numbers.
Deletes all entries from the allow rules or deny rules list
or both.
Creates a firewall rule for inclusion in the deny
rules list.
Displays the current stateful firewall settings and
configured rules.
Allows modification of an existing firewall rule.
Enables or disables the stateful firewall function.
Sets the threshold of packets dropped per second
(due to firewall rules) that when exceeded, will log
a message to the console.
Chapter 18: Stateful Firewall Commands
CHAPTER 18
For Internet firewall filtering commands,
Commands.
Function
Page 18-1