Eth Vrrp List; Eth Vrrp Set Multicast - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

eth vrrp list

Lists the VRRP attribute records for the port and shows the status of the VRRP router.
For more information, see
Guide.
Mgmt Class
Network (R)
Input Format
eth vrrp list [<port#>]
Parameters
a
<port#>
a
The default is 0; the parameter may be omitted if the router has only one port.
Response
Typical response listing the attribute records for the default port 0.
-> eth vrrp add 7
VRRP Records for Ethernet Port.
VRRP Record...................

eth vrrp set multicast

Changes the multicast address used for VRRP router announcements. This address
is used by all VRRP announcements from this router, regardless of VRID or port. For
more information, see
Guide.
NOTE:
This command is not usually needed for VRRP configuration. Do not use this
command unless you clearly understand its impact.
NOTE:
This command takes effect immediately, but you must save the change if it is to
persist after you restart the interface or reboot the router.
®
Efficient Networks
"VRRP Backup" on page 6-16
Physical Ethernet interface (port) number.
"VRRP Backup" on page 6-16
Chapter 5: Ethernet Interface Commands
of the Technical Reference
0
VRID 8, Priority 100, Interval 1
Flags: preempt, No Authentication
Interface: ETHERNET/0:3
Primary WAN interface is down
of the Technical Reference
Page 5-43