Eth Vrrp Set Password - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide
Mgmt Class
Network (R/W)
Input Format
eth vrrp set option preempt | nopreempt <vrid> [<port#>]
Parameters
preempt
nopreempt
a
<vrid>
b
<port#>
a
Integer, 1 - 255
b
The default is 0; the parameter may be omitted if the router has only one port.
Example
This command specifies no preemption for VRID 7 using default port 0.
-> eth vrrp set option nopreempt 7
Response
Command prompt.

eth vrrp set password

Specifies the password in a VRRP attribute record for the VRID (virtual router ID). The
password is used to authenticate VRRP advertisement packets. It is sent as clear text
on the LAN. For more information, see
Reference Guide.
NOTE:
If you do not specify a password, no authentication is performed.
To see the current password, use the command eth vrrp list. To clear a password, use
the command
®
Efficient Networks
Preempt immediately.
Do not preempt a router with lower priority.
Virtual router ID of the VRRP attribute record (integer, 1-255). The at-
tribute record was created by the command
Physical Ethernet interface (port) number (0 or 1).
eth vrrp clear password.
Chapter 5: Ethernet Interface Commands
eth vrrp add
"VRRP Backup" on page 6-16
.
of the Technical
Page 5-45