Table of Contents
Advertisement
®
Efficient Networks
Router family
Command Line Interface Guide
Parameters
Must be one of the following:.
<option>
rxrip
rxrip1
rxrip2
rxdef
txrip
txrip1
txrip2
txdef
advfr
multicast
<interface>
a
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must
be specified.
b
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Response
Command prompt.
eth ip ripmulticast
Changes the multicast address for RIP-1 compatible and RIP-2 packets. The default
address is 224.0.0.9. For more information, see
Technical Reference Guide.
Mgmt Class
Network (R/W)
Input Format
eth ip ripmulticast <ipaddr>
®
Efficient Networks
Receive and process IP RIP-1 compatible and RIP-2 broadcast
packets from the Ethernet LAN. Also receive and process RIP-
2 packets that are multicast as defined by the eth ip ripmulticast
command. Set this option if the local router is to discover route
information from the Ethernet LAN. The default is on.
Receive and process RIP-1 packets only.
Receive and process RIP-2 packets only.
Receive the default route address from the Ethernet LAN. The
default is on. This option is useful if you do not want to configure
your router with a default route.
Transmit RIP-1 compatible broadcast packets and RIP-2 multi-
cast packets over the Ethernet LAN. The default is on.
Transmit broadcast RIP-1 packets only.
Transmit broadcast RIP-2 packets only.
Advertise this router as the default router over the Ethernet
LAN (provided it has a default route). The default is on. Set this
to off if another router on the local LAN is the default router.
Enables this Ethernet interface to forward IP multicast traffic.
a,b
Ethernet interface.
Chapter 5: Ethernet Interface Commands
"RIP Controls" on page 6-4
of the
Page 5-29
Advertisement
Table of Contents
