Eth Ip Vrid - Efficient Networks Router family Command Line Interface Manual

Chapter 5: Ethernet Interface Commands

eth ip vrid

Assigns a virtual router ID (VRID) to an Ethernet interface. The same VRID must be
assigned to the master router and its backup routers. For more information, see
"VRRP Backup" on page 6-16
This command designates the interface as the VRRP interface for the router. You
must use another logical Ethernet interface as the management interface for the
router. To create a new logical Ethernet interface, use the command
assign it an IP address with an
NOTE:
The assignment takes effect after a
reboot the router.
After assigning the VRID, its attributes may be specified with the eth vrrp commands
(see eth vrrp
If you delete the VRID (eth vrrp delete), the VRRP interface designation is cleared.
You can also clear the VRRP interface designation by entering the
command with 0 as the VRID.
Mgmt Class
Network (R/W)
Input Format
eth ip vrid <vrid> [<interface>]
Page 5-32
of the Technical Reference Guide.
eth ip addr
add).
Efficient Networks
Command Line Interface Guide
command.
save the change and restart the interface or
®
Router family
eth add and then
eth ip vrid
®
Efficient Networks