Table of Contents
Advertisement
®
Efficient Networks
Router family
Command Line Interface Guide
remote setmaxline
Sets the maximum links (1 or 2) for a DOD (dial on demand) connection, that is, a
connection where the link goes up and down. These links include those for ISDN,
L2TP tunnels, IPSec tunnels, and dial backup.
If you set the maximum links to 2, bandwidth on demand management determines
their actual usage; see the
Mgmt Class
Network (R/W)
Input Format
remote setMaxLine
Parameters
1 | 2
<remotename>
a
ASCII string
Response
Command prompt.
remote setmgmtipaddr
Assigns to the remote router entry, an IP address which is to be used for management
purposes only and not for IP address translation. This management IP address is
generally a private network address used solely by the ISP.
The management IP address is separate from the IP address used for IP address
translation. The IP address used for address translation is generally a public IP
address valid on the Internet. It is set by the
NOTE:
The management address is not effective until after the next
or reboot.
®
Efficient Networks
remote setbwthresh
1 | 2 remotename>
Maximum number of links to be used for the connection (1 or 2).
The default is 1.
a
Name of the remote router.
Chapter 6: Remote Commands
command.
remote setsrcipaddr
command.
save
and
remote restart
Page 6-51
Advertisement
Table of Contents
