Sntp Prefserver - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide
Response
-> sntp offset
Current offset from UTC is 0 minutes
Use <system sntp offset> to set time zone
usage: sntp offset <Minutes from UTC>
(offset is negative for west, positive for east of Greenwich meridian)
-> sntp offset -360

sntp prefserver

Displays or changes the preferred SNTP server. (The preferred server is the server
that should be attempted first when a request is made.)
To specify a server preference, specify the number of the preferred server within the
SNTP server list. To see the SNTP server list, enter
To see the active SNTP server (that is, the server that last responded to an SNTP
request), use the command
NOTE:
To make this change permanent, a
Mgmt Class
Admin (R/W)
Input Format
sntp prefserver <number>
Parameters
***
a
<number>
a
Integer
Response
When entered with no <number> parameter:
-> sntp prefserver
The preferred SNTP server is 1 (192.6.38.127)
®
Efficient Networks
sntp active.
save
When no parameter is entered, current preferred server displayed.
Number of a server within the SNTP server list.
Chapter 2: Status Commands
sntp server.
must be performed before a reboot.
Page 2-25