Eth Ip Delroute - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

eth ip delroute

Removes a route from the default routing table that was added using the
addroute command.
The route to be deleted is identified by its IP address and mask and its Ethernet
interface. To see the remaining routes, use the
NOTE:
This command requires a
Mgmt Class
Network (R/W)
Input Format
eth ip addroute <ipaddr> <ipnetmask> [<interface>]
Parameters
<ip addr>
<ipnetmask>
<interface>
a
Dotted-decimal notation
b
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1)
must be specified.
c
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Examples
The following command deletes the route for IP address 10.9.2.0/255.255.255.0 for
the default Ethernet interface (0:0).
-> eth ip delroute 10.9.2.0 255.255.255.0
The following command deletes the route for IP address 10.1.3.0/255.255.255.0 for
the Ethernet interface 0:1.
-> eth ip delroute 10.1.3.0 255.255.255.0 0:1
Response
Command prompt.
®
Efficient Networks
save and
a
Ethernet LAN IP address.
a
IP network mask.
b,c
Ethernet interface.
Chapter 5: Ethernet Interface Commands
iproutes command.
reboot before it takes effect.
eth ip
Page 5-15