Table of Contents
Advertisement
Chapter 5: Ethernet Interface Commands
Command
eth ip addroute
eth ip addserver
eth ip bindroute
eth ip defgateway
eth ip delhostmapping
eth ip delroute
eth ip delserver
eth ip directbcast
eth ip disable
eth ip enable
eth ip filter
eth ip firewall
eth ip mgmt
eth ip options
eth ip ripmulticast
eth ip translate
eth ip unbindroute
eth ip vrid
Page 5-2
Table 5-1: Ethernet Interface Command Listing (Cont.)
Adds a route to the default routing table for the
Ethernet interface.
This Network Address Translation (NAT) com-
mand adds a server's IP address (on the LAN) as-
sociated with this interface for a particular protocol.
Adds an Ethernet route to the named IP virtual
routing table.
Assigns an Ethernet default gateway for packets
whose destination address does not have a route
defined.
Undoes an IP address/ host translation (remap-
ping) range.
Removes a route from the default routing table.
Deletes a server entry.
Enables or disables the forwarding of broadcast
packets directed to a specific network prefix.
Disables IP routing across the Ethernet LAN.
Enables IP routing across the Ethernet LAN.
Manages the IP filters for the Ethernet interface(s).
Enables and disables Ethernet Firewall Filtering.
Assigns to an Ethernet interface an IP address
which is to be used for management purposes only
and not for IP address translation.
Enables or disables an IP option for the specified
Ethernet interface.
Changes the multicast address for RIP-1 compati-
ble and RIP-2 packets.
Controls Network Address Translation on a per-in-
terface basis.
Removes an Ethernet route from the named IP vir-
tual routing table.
Assigns a virtual router ID (VRID) to an Ethernet in-
terface.
Efficient Networks
Command Line Interface Guide
Function
Efficient Networks
®
Router family
®
Advertisement
Table of Contents
