Eth Ip Options - Efficient Networks Router family Command Line Interface Manual

Chapter 5: Ethernet Interface Commands
Parameters
<ip addr>
<ipnetmask>
<interface>
a
Dotted-decimal notation
b
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must
be specified.
c
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Example
-> eth ip mgmt 10.0.0.1 255.255.255.0 0:1
-> save
-> reboot
Response
Command prompt.

eth ip options

Enables or disables an IP option for the specified Ethernet interface. The IP options
include:
• Options to transmit or receive RIP-1 and/or RIP/2 packets. (see
Controls" on page 6-4
• Option to advertise this router as the default router.
• Option to enable forwarding of IP multicast traffic.
NOTE:
This command is not effective until after
performed.
Mgmt Class
Network (R/W)
Input Format
eth ip options <option> on | off [<interface>]
Page 5-28
a
Ethernet IP address.
a
IP subnet mask.
b,c
Ethernet interface.
of the Technical Reference Guide.)
Efficient Networks
Command Line Interface Guide
save and reboot commands have been
®
Router family
"RIP
®
Efficient Networks