Remote Setmtu - Efficient Networks Router family Command Line Interface Manual

Chapter 6: Remote Commands

remote setmtu

Sets the maximum transfer unit for the remote interface.
To see the current MTU size for an active remote that is doing IP routing, use the
command. To change the MTU for an Ethernet interface, use the command
If the protocol in use is PPP, you can see the MRU and MTU sizes using the
command mlp show. The MRU is the maximum receive unit. Other information in the
mlp show output includes the maxtu (the maximum packet size that can be sent; it is
based on the peer's MRU size), the ourmru (the maximum PPP packet size that can
be received if multilink is not running), and ourmrru (the maximum PPP packet size
that can be received if multilink is running).
Input Format
remote setmtu <size> <remotename>
Parameters
a
<size>
<remotename>
a
Integer
b
ASCII string
Example
The following command decreases the MTU size for remote interface HQ to 1400
bytes.
-> remote setmtu 1400 HQ
Response
Command prompt.
Page 6-54
Maximum number of bytes that can be transferred as a unit.
b
Name of the remote router.
®
Efficient Networks Router family
Command Line Interface Guide
Efficient Networks
ipifs
eth mtu.
®