L2Tp Set Ouraddress - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide
Input Format
l2tp set hiddenAVP yes | no <tunnelname>
Parameters
yes
no
<tunnelname>
a
ASCII string
b
The name is case sensitive.
Response
Command prompt.

l2tp set ouraddress

Specifies the source IP address used when the tunnel is originated.
Use this command when you want to specify a source IP address other than the WAN
interface IP address. For example, if NAT (network address translation) is not being
used, all IP addresses on the Ethernet LAN would be visible. You could then specify,
as the source IP address, the Ethernet IP address of the router (which would be
visible) instead of the WAN interface IP address.
Mgmt Class
Security (R/W)
Input Format
l2tp set ouraddress <ipaddr> <tunnelname>
Parameters
a
<ipaddr>
<tunnelname>
a
Dotted-decimal notation.
b
ASCII string
c
The name is case sensitive.
Response
Command prompt.
®
Efficient Networks
Allows the router hide AVPs. Default value.
Disables hidden AVPs.
a
Name of the tunnel.
Source IP address used for this tunnel.
b
Name of the tunnel.
Chapter 9: L2TP Commands
b
c
Page 9-11