Remote Setbroptions - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

remote setbroptions

Sets controls on bridging for the remote router entry. To see the current bridging
settings for remote router entries, use the
CAUTION:
Do not change the <stp> setting without approval from your system administrator.
Mgmt Class
Network (R/W)
Input Format
remote setBrOptions <option> on | off <remotename>
Parameters
option l
stp
pppoe
<routername>
a
The Spanning Tree Protocol adds a 40-second delay each time the ADSL or ATM link comes up while
the interface determines if there is a bridging loop.
b
ASCII string
Examples
The following example command requests the spanning tree protocol for remote
router HQ.
-> remote setBrOptions stp on HQ
The following example command configures remote router PPPoEbridge as the
remote through which only PPPoE traffic is bridged.
-> remote setBrOptions pppoeonly on PPPoEbridge
Response
Command prompt.
®
Efficient Networks
Set this option to on to use the Spanning Tree Protocol (STP). The
default is on.
a
Set this option to on to limit this remote router entry to bridging PP-
PoE traffic only. If the option is set to off, then the entry can bridge
any traffic, including PPPoE traffic. The default is off.
b
Name of the remote router
Chapter 6: Remote Commands
remote listbridge command.
Page 6-43