Table of Contents
Advertisement
Chapter 6: Remote Commands
remote restart
Stops the current active session and starts a new active session for a remote.
Certain configuration changes for a remote become effective only after the remote is
restarted or the router is rebooted. Remember to save the changes before the restart
or reboot.
NOTE:
Use restart instead of reboot whenever possible. A restart does not affect other
interfaces, allowing their traffic to continue. For example, using restart, you can add
an IP route without killing voice traffic.
To restart an Ethernet interface, use the
Mgmt Class
Network (R/W)
Input Format
remote restart <remotename>
Parameters
<remotename>
a
ASCII string
Response
Command prompt.
remote setatmnsap
RFC1577 (Classical IP over ATM) specifies a mechanism to map an ATM Name
(called an NSAP) to a PVC. NSAP's are normally not needed, but if they are used,
they have a syntax defined by using either the ATM or E164 encodings. By
convention, octets 2-7 contain a unique identifier for the router, such as a MAC
address.
In the command remote setATMnsap, the complete 20 octets of the NSAP are
specified. If Partial mode is selected, the router substitutes the MAC address of the
router for octets 2-7. In Full mode, no change is made to the NSAP.
To see an ATM NSAP that has been set, use the
Page 6-40
a
Name of the remote router.
Efficient Networks
Command Line Interface Guide
eth restart
command.
remote list
command.
®
Router family
®
Efficient Networks
Advertisement
Table of Contents
