User Add Class - Efficient Networks Router family Command Line Interface Manual

Chapter 15: User Commands

user add class

Configures the managements class with read-only or read-write privileges for the
specified user. Multiple class and privilege pairs may be specified for a user. To view
the current management class(es) for a user, use the command
NOTE:
If a user account currently has read-write privilege for a management class, adding
the same user class with a read-only privilege will not revoke the read-write privilege.
To revoke the read-write privilege, use the
establish the management class with read-only access.
Mgmt Class
Admin (R/W)
Input Format
user add class <class> read | write <user_name>
Parameters
<class>
read
write
<user_name>
a
ASCII string, 6 - 32 characters. User name is case sensitive.
Response
A typical response is shown below.
-> user add class security write Admin1
Added "SECURITY-WRITE" management class for user "Admin1"
Page 15-4
Must be one of the following:
Adds Admin management class for the specified user ac-
admin
count.
Adds voice management class for the specified user account.
voice
Adds network management class for the specified user ac-
network
count.
Adds system management class for the specified user ac-
system
count.
Adds security management class to the specified user ac-
security
count.
Adds debug management class to the specified user account.
debug
Class privileges are granted on a read-only access.
Class privileges are granted for read and write access.
a
User account to which the management class is added.
Efficient Networks
Command Line Interface Guide
user delete class command, then re-
®
Router family
user list.
®
Efficient Networks