Ike Peers Set Mode - Efficient Networks Router family Command Line Interface Manual

Chapter 12: IKE/IPsec Commands

ike peers set mode

Sets the IKE peer connection mode to either main mode or aggressive mode. Main
mode is used when the IP addresses of both ends are known and constant.
Aggressive mode is used when the address of one end can change, as with a typical
modem or DSL connection. (See
Mgmt Class
Security (R/W)
Input Format
ike peers set mode <main | aggressive> <peername>
Parameters
Choose one of the following:
main
aggressive
<peername>
a
ASCII string
b
To see the peer names, use the
Example
-> ike peers set mode aggressive my_aggressive_peer
Response
Command prompt.
Page 12-36
"Main Mode and Aggressive Mode" on page
Select main mode (both ends constant).
Selects aggressive mode (one end can change).
a
Name of the IKE peer whose mode is specified.
ike peers list
Efficient Networks
Command Line Interface Guide
command.
®
Router family
5-54.)
b
®
Efficient Networks